Victron Energy BatteryProtect 12/24V-220A

Victron Energy BatteryProtect 12/24V-220A

Victron Energy BatteryProtect – 12/24V, 220A

Protect Your Battery, Extend Its Life

The Victron BatteryProtect 12/24V – 220A is designed to disconnect your battery from non-essential loads before it becomes dangerously discharged—preserving battery health and preventing system failure. It also ensures there's enough power left to start your engine or power critical equipment.

Key Features:

• 12/24V Auto-Ranging
  Automatically detects system voltage (12V or 24V) for easy installation.
• High Current Capacity – 220A
  Ideal for larger systems requiring high-current load protection.
• Protects Against Deep Discharge & Overvoltage
  Automatically disconnects loads if voltage drops too low or exceeds 16V/32V to protect sensitive electronics.
• Programmable Disconnect & Reconnect Thresholds
  Customize voltage settings easily using the integrated 7-segment display.
• Delayed Disconnect/Reconnect Logic
  Load disconnect is delayed by 90 seconds after a low-voltage condition. Reconnect occurs 30 seconds after voltage returns to normal, avoiding unnecessary power cuts.
• Delayed Alarm Output
  Sends a signal (max 50mA) to trigger buzzers, LEDs, or relays if low voltage persists for 12 seconds—ignition-safe design ensures it won’t trigger during engine starts.
• MOSFET-Based, Ignition-Proof Switching
  No mechanical relays—ensures silent operation and eliminates sparks.
• Ultra Low Power Consumption
  Especially useful in Li-ion battery systems to prevent unnecessary drain during standby.

Li-Ion Battery Support:

• Dedicated Li-ion Mode
  Integrates seamlessly with Victron’s VE.Bus BMS for advanced LiFePO4 battery protection.
• Can Function as a Charge Interrupter
  Allows use between a charger and a lithium battery to stop charging at unsafe voltage levels.

Important Note:

The BatteryProtect is uni-directional—designed for current to flow from the Battery terminal to the Load terminal only. For use with a charger, connect the charger to the Battery terminal (not the Load side).

Safeguard your battery investment and automate power control with the Victron BatteryProtect 220A—a must-have for any 12V or 24V electrical system.